MINN KOTA TALON Mode D'emploi page 12

INSTALLING THE TALON
3
ITEM(S) NEEDED
#2 x 4
e. Take each of the four 3-1/2" Stainless Steel Bolts
(Item #2) and place one Flat Washer (Item #4) on
them. Place one Bolt in each of the Mounting Holes
so that is passes through the Mounting Bracket and
the drilled holes on the transom of the boat.
f. Place a Fender Washer (Item #6) on the end of each
Bolt on the inside of the Transom and secure each
with a Nylock Nut (Item #8). Tighten the bolts with a
1/2" Box End or Socket Wrench. Do not over-tighten.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize will help prevent seizing.
4
g. Once the Mounting Bracket is secured, note the
Mounting Straps located on the inside of the
Mounting Bracket. The Mounting Straps need
to be adjusted so that they are as perpendicular
as possible to the waterline. The five Angular
Adjustment Holes located on one end of the
Mounting Straps allows for 25 degrees of motion
to accommodate the variability of different transom
styles.
h. If the Mounting Straps are not perpendicular,
use a 9/16" Box End or Socket Wrench to adjust
the Nylock Nuts. The Bolt that passes through
the Mounting Strap, opposite from the Angular
Adjustment Holes should be loosened, but not
removed.
12 | minnkotamotors.com
#4 x 4 #6 x 4
3e
Transom
3f
4g
Mounting
Bracket
Angular
Adjustment
Holes
Perpendicular
Placement
4h
Mounting
Bracket
Angular
Adjustment
#8 x 4
Mounting
Bracket
Nylock Nut
Fender
Washer
Transom
Mounting
Straps
Water
Line
Right-side-up
Nylock
Nuts
Holes
Right-side-up
Stainless
Steel Bolt
Flat Washer
Mounting
Bracket
4g
Angular
Adjustment
Holes
Mounting
Straps
Mounting
Bracket
Perpendicular
Placement
Water
Up-side-down
Line
4h
Angular
Adjustment
Holes
Mounting
Bracket
Nylock
Up-side-down
©2017 Johnson Outdoors Marine Electronics, Inc.
Nuts