Troubleshooting - MINN KOTA TALON Mode D'emploi

TROUBLESHOOTING

TROUBLESHOOTING
1. Why do I want to be able to adjust the Talon up or down when mounting on my boat?
• Each boat sits differently in the water, and has varying amounts of draft (hull under the waterline). While Minn Kota recommends
that the Talon mounting bracket be mounted as high up on the transom as possible, Minn Kota also recommends that the bottom of
the Talon be a minimum of 4" up from the bottom line of the hull of your boat. Having this adjustability will minimize any spray that
may occur while under way, and offer the greatest amount of stability to the Talon.
2. When do I want to use the reverse angle on the bracket when mounting the Talon?
• Some boat models have transoms that angle towards the inside of the boat. In these cases, the Talon quick release bracket can be
inverted to account for this reversed angle without the hassle of shims.
3. Do I need a separate battery to operate the Talon?
• No. Minn Kota recommends connecting your Talon to the starting/cranking battery of your boat.
4. Can I install an electrical plug on the Talon lead wires?
• Yes. Minn Kota offers a quick disconnect plug accessory (1810244) specifically designed for the Talon.
5. How do I determine where and how to mount the Talon?
• This will vary from one boat to the next. It is important to check for proper steering and trimming clearances when laying out your
installation. See the Installation section of this Manual for detailed instructions.
6. Which side of the boat do I want to install the Talon?
• Minn Kota recommends installing your Talon on the port (left) side of your boat in order to give you the maximum amount of
clearance between the boat engine and the control panel of the Talon. However, the Talon can be installed on either side or both
sides of the boat.
7. How do I mount the Talon when I have trim tabs?
• Talon requires a minimum of 6" of clearance from the mounting surface. If further clearance is required, or it is necessary to mount
over top of trim tabs, Minn Kota offers a 6" riser accessory and a variety of adapter plates that will give you the proper amount of
setback (distance from the transom) to clear trim tabs and/or other accessories.
8. How do I know when I should use a mounting adapter bracket?
• Some boats have irregular-shaped transoms and the standard Talon quick release mounting bracket cannot be mounted directly
to the transom. In other cases there are other accessories such as trim tabs, transducers, poling platforms, etc., that may require
additional clearance. Use the Talon Adapter Bracket Selection Guide to select the proper application for your boat.
NOTICE:
For all other malfunctions, visit an Authorized Service Center. You can search for an Authorized Service Center in your
area by visiting our Authorized Service page, found online at minnkotamotors.com, or by calling our customer service number at
800-227-6433.
50 | minnkotamotors.com
©2017 Johnson Outdoors Marine Electronics, Inc.