Clearing Paired Talons From The Remote; Manually Retract The Talon - MINN KOTA TALON Mode D'emploi

2
NOTICE:
another person.
c. While holding in the Up
Panel, restore power to the Talon. A series of fast
beeps will be heard followed by a long steady tone.
d. After the steady tone stops, release the Up
button.

CLEARING PAIRED TALONS FROM THE REMOTE

The Remote was designed so that all paired Talons can be cleared from memory.
1
a. Press and hold the Up
button on the Remote at the same time until the
Talon Selection LEDs on the Remote begin to scroll,
release the buttons. The Remote will go into Pairing
Mode for 20 seconds. Once Pairing times out all
Talons will be cleared.
NOTICE:
Putting the Remote into Pairing Mode,
even if it is accidental, without Paring the Remote
to a Talon will clear all paired Talons.

MANUALLY RETRACT THE TALON

In the event that you ever need to manually retract the Talon,
follow the procedure below.
1
a. Press and hold the Up
Panel until you hear 3 successive beeps. This will
put the Talon in Manual Retraction Mode.
b. Remove the Rubber Cap on the Manual Retraction
Hex-Drive and use a 7/16" Socket Wrench, to turn
the Hex-Drive in a clockwise direction.
CAUTION
The Talon may become slippery when wet. Be careful not
to not slip and fall when adjusting the Manual Retraction
Hex-Drive.
©2017 Johnson Outdoors Marine Electronics, Inc.
CLEARING PAIRED REMOTES OR DEVICES FROM THE TALON
This may require assistance from
button on the Indicator
button and the Down
button on the Indicator
Power Cable
Positive Lead
NOTICE:
The Talon would need to be in a deployed state
when the Manual Retraction Procedure is used.
1a
Up Button
Indicator
Panel
Deployment
Notification
Alarm Wire
Negative Lead
Fuse
Assembly
Talon Selection LEDs
Auto Up/Down
Buttons & Pairing
Button
1b
Manual
Retraction
Hex-Drive
minnkotamotors.com | 43