Pairing Two Talons And Programming The Mounting Location - MINN KOTA TALON Mode D'emploi

PAIRING TWO TALONS AND PROGRAMMING THE MOUNTING LOCATION

PAIRING TWO TALONS AND PROGRAMMING THE MOUNTING LOCATION
Every Talon comes direct from the factory with 2 remotes already paired to the Talon. However, any Talon can be paired with up to 3
devices per Talon. When a boat has two Bluetooth enabled Talons installed, it is necessary to pair both Talons together, and to program
which side of the boat each Talon is installed on. The process below is used to pair the Talons together, and to designate which side
of the boat the each Talon is installed on. When the process is complete, all remotes that were paired to an individual Talon will now
operate both Talons. If not, please see the "Pairing a remote to two Talons" section of this manual. Adding more than 3 devices per
Talon may affect communication within the Bluetooth network.
1
a. Retract the anchor on both Talons by pressing the Up
button on each Talon.
b. Once both Talons are fully retracted, press and
hold the Up
the Indicator Panel of one Talon. Once the Depth
Indication LEDs on the Indicator Panel begins to
flash blue, release the buttons. Immediately follow
this step on the second Talon.
c. Once the buttons are released, the Talons are in
Pairing Mode and will search for each other for 20
seconds. If they do not Pair after 20 seconds, an
error tone will sound signaling that the Pairing has
timed out. If this occurs, double check that the
Talons are fully retracted and start the process again.
d. If the Talons successfully Pair, a confirmation tone
with three fast beeps will occur. At this point, the
Talons have successfully paired, and now need to
be programmed to designate the Port or Starboard
locations.
2
NOTICE:
when two Talons have successfully paired to
each other.
e. The Mode Indicator LED will turn green on both
Talons. On the Indicator Panel of the Starboard
Talon, press the Up
the selection. The Talon on the Port side will flash
red and then the LEDs on both Talons will turn off.
Now the Talons are successfully Paired together and
know their mounted position.
©2017 Johnson Outdoors Marine Electronics, Inc.
button and the Down button on
This process will automatically begin
button. The Talon will accept
1a
Up Button
1b
Talon 1
Up Button
Down Button
Indicator
Panel
1e
Starboard Talon
Up Button
Indicator
Panel
Talon 2
Up Button
Down Button
Indicator
Panel
Mode Indicator LED
minnkotamotors.com | 41