MINN KOTA TALON Mode D'emploi page 13

5
i. Next, note the position of the nuts, washers and
screws holding the Mounting Strap in place. The Hex
Head Cap Screws pass from the inside to the outside
of the bracket. They first pass through the Mounting
Strap, then a Guard Washer, then the Mounting
Bracket. On the outside of the bracket, the screw
first holds a Flat Washer and then a Lock Washer
before being secured with a Nylock Nut.
j. After the appropriate Nylock Nut has been loosened,
locate the Nylock Nut opposite of the loosened one
on the Mounting Strap and remove it.
k. Adjust the Mounting Straps so that they are as
perpendicular to the waterline as possible.
CAUTION
Do not use the Mounting Bracket or Talon as a step to enter
the boat. The bracket will be slippery when wet and is not
designed to support people. Using this product as a step
may result in injury.
6
l. Once perpendicular, replace the hardware that
was removed by selecting one of the five Angular
Adjustment Holes that will support the Mounting
Strap at the most perpendicular position.
m. To replace the bolts, pass them from the inside to
the outside, through the Mounting Strap, then the
Guard Washer, then the Mounting Bracket, a Flat
Washer and Lock Washer. Then loosely secure with
a Nylock Nut. The nuts will be fully secured later in
the installation.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
The hardware holding the Mounting Straps in place
has a pre-applied anti-seize.
©2017 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE TALON
5i
Nylock
Nut
Lock
Washer
Mounting
Bracket
Flat Washer Washer
5k
Mounting
Mounting
Straps
Bracket
Water
Angular
Line
Adjustment
Holes
Perpendicular
Placement
Right-side-up
Nylock
Nut
Lock
Washer
Flat Washer
Mounting
Bracket
Guard
Washer
Hex Head
Cap Screw
Mounting
Strap
Mounting
Strap
Guard
Washer
Guard
Hex Head
Cap Screw
5k
Angular
Adjustment
Holes
Mounting
Bracket
Perpendicular
Water
Placement
Line
Up-side-down
Mounting
Strap
Hex Head
Guard
Washer
Mounting
Bracket
Lock
Washer
Flat Washer
minnkotamotors.com | 13
Mounting
Bracket
Nylock
Nut
Mounting
Straps
Cap
Screw
Nylock
Nut