Mode Functions - MINN KOTA TALON Mode D'emploi

Mode Functions

The Talon operates in three different modes. Each Mode is designed for a specific on water scenario and changes the anchoring
behavior of the Talon when it deploys. Talon is capable of anchoring in most conditions and it is important to select the right anchoring
mode. The three different Mode functions are:
1. Standard Mode - Standard Mode is the default anchoring Mode for Talon. When put in Standard Mode, the Mode Indicator LED in the
Indicator Panel will toggle between red and green and then turn
off. In Standard Mode, Talon's Auto Deploy will operate with
maximum down-force with a complete Auto-Drive cycle of three
hits spaced at three seconds apart.
2. Soft Bottom Mode - In Soft Bottom Mode, the Mode Indicator
LED will be lit green on the Indicator Panel. In Soft Bottom
Mode, the Auto Deploy will operate at a reduced power with a
single hit.
3. Rough Water Mode - In Rough Water Mode, the Mode LED
Indicator on the Indicator Panel will be lit red. In Rough Water
Mode, the Auto Deploy will operate with maximum down-force
with three Auto-Drive cycles of three hits each, spaced 3 seconds
apart. The three Auto-Drive cycles will be spaced at 10 second intervals.
STANDARD MODE
3 Seconds 3 Seconds
Single Auto-Drive Cycle
©2017 Johnson Outdoors Marine Electronics, Inc.
SOFT BOTTOM MODE
Single Hit
NOTICE:
During calm conditions or on water with muddy
or soft sandy bottoms, Soft Bottom Mode will prevent the
Talon from over-anchoring.
NOTICE:
If power is cycled to the Talon, the Talon will
"remember" if it was last in "Standard Mode" or "Soft
Bottom Mode," and will return to that last known mode.
However, if it is left in "Rough Water Mode," and power
is cycled, it will default to "Standard Mode." This is done
to prevent Talon from unnecessarily over-anchoring.
ROUGH WATER MODE
3 Seconds
Auto-Drive Cycle Repeated 3 Times
TALON FEATURES
3 Seconds
10 Second Interval
minnkotamotors.com | 27