MINN KOTA TALON Mode D'emploi page 16

INSTALLING THE POWER CABLE AND DEPLOYMENT NOTIFICATION ALARM WIRE
2
c. Align the closest set of holes in the shield with the
holes in the bottom of the Mounting Bracket. The
set of holes used on the shield will vary for each
individual installation.
NOTICE:
The Water Deflection Shield will always
be installed on the bottom side of the Mounting
Bracket regardless of the orientation that the
Mounting Bracket was installed. There should be no
gap between the shield and the Talon.
3
ITEM(S) NEEDED
#24 x 1
d. Take two each of the 1/2" Washers (Item #22) and
two of the 1" Phillips Pan Head Screws (Item #24) to
attach the shield to the Mounting Bracket. Place one
washer on each of the screws. The screw should pass
through a washer, then the Water Deflection Shield
and into the Mounting Bracket. Secure the screws
using a #2 Screwdriver.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Applying an anti-seize may help prevent seizing.
NOTICE:
If you adjust the angle of your Talon after
this step is complete, you will need to re-adjust the
placement of the Water Deflection Shield to ensure
proper functionality.
16 | minnkotamotors.com
#22 x 1
2c
Talon
Assembly
Mounting
Bracket
Mounting
Bracket
Water
Hole
Deflection
Shield
3d
Talon
Assembly
Mounting
Bracket
Water
Deflection
Shield
Washer
Phillips Pan
Head Screw
2c
Talon
Assembly
Water
Deflection
Shield
Mounting
Mounting
Bracket
Bracket
Hole
3d Talon
Assembly
Water
Deflection
Shield
Mounting
Bracket
Washer
Phillips Pan
Head Screw
©2017 Johnson Outdoors Marine Electronics, Inc.