Pairing A Remote To A Single Talon - MINN KOTA TALON Mode D'emploi

PAIRING A REMOTE TO A SINGLE TALON

PAIRING A REMOTE TO A SINGLE TALON
Every Talon comes direct from the factory with 2 remotes already paired to the Talon. However, any Talon can be paired with up to 3
devices per Talon.
1
a. Retract the anchor on the Talon by pressing the Up
button.
b. Once the Talon is fully retracted, press and hold the
Up button and the Down
Remote at the same time until the Talon Selection
LEDs on the Remote begin to scroll. Then release
them.
c. Immediately press and hold the Up
the Down
Panel. The Depth Indication LEDs will begin to flash
blue. Once the LEDs are flashing release the buttons
on the Indicator Panel. The Talon and Remote will
go into Pairing Mode for 20 seconds. If a signal
with three fast beeps occurs, the Talon and Remote
have successfully paired. If 20 seconds pass while
in Pairing Mode and they do not successfully pair, a
chirp will sound signaling that the Pairing has timed
out.
d. If the Pair is unsuccessful, repeat the process.
40 | minnkotamotors.com
button on the
button and
button simultaneously on the Indicator
1a
Up Button
Down Button
Talon Remote
Indicator
Panel
Talon Selection LEDs
Auto Up/Down
Buttons & Pairing
Button
©2017 Johnson Outdoors Marine Electronics, Inc.