Adjusting The Tilt/Extend Tiller; Push-To-Test Battery Meter - MINN KOTA 1355920 Mode D'emploi

PUSH-TO-TEST BATTERY METER

Adjusting the Tilt/Extend Tiller

Your trolling motor features 7 usable handle tilt positions: 45°, 30°, and 15° up and down from the 0° (horizontal) position. To use the
down positions, you must first press the release button located on the left underside of the pivot handle.
Your trolling motor handle also features a unique stow position, that is useful for limiting the amount of space required for storage or travel.
1
a. First press the release button located on the left
underside of the pivot handle, then push the handle
down until you feel the handle "lock in" to the
stowed position. This will be almost parallel to the
motor shaft.
b. To extend the handle, pull the handle towards you to
the desired position. The handle will extend a full 6
inches. To retract, push the handle in until it
meets the face of the motor control head.
WARNING
The position of the Tilt/Extend Tiller may create a pinch
point between it and the Control Head. Grasp the motor
away from the area that may come in contact with another
area of the motor to prevent injury.
Before attempting to put the handle in the stowed position, the speed selector must be in the OFF/STOW position. Failure to do so
will damage the internal mechanism.
20 | minnkotamotors.com
Handle Controls: Handle Controls:
Off/On, Steering, and Off/On, Steering, and
Forward/Reverse Forward/Reverse
CAUTION
Release Button Release Button
©2021 Johnson Outdoors Marine Electronics, Inc.