MINN KOTA TALON Mode D'emploi page 46

REPLACE THE SPIKE
INSTALLATION
1
a. Press the Down
the Down
Spike out so that the Second Stage begins to exit
the bottom of the Talon. This may require removing
the Talon from the Mounting Bracket, and laying it
horizontally or on a flat surface.
b. Once extended, remove the Talon from the Power
Source.
CAUTION
Before beginning any maintenance work, disconnect the
Talon from the battery or if connected to a battery selector
switch or power disconnect switch, make sure that it is
turned to the "off" position. Failure to disconnect power
during maintenance work may result in shock, unexpected
operation and/or injury.
2
c. Locate the Spike Isolator Retainer Pin in the Second
Stage of the Talon. Carefully remove the Retainer Pin
using a Pin Punch and Hammer.
d. Set the Spike Isolator Retainer Pin aside for later
use, in reassembly. Slide the Spike Isolator along the
Spike, away from the Second Stage.
e. Gently pivot the Second Stage Debris Shield up
out of the way to access the Spike Retainer Screw.
The adjacent plastic Debris Channel Tab will bend
slightly, but can be tapped back into place with a
small hammer after the Spike is replaced.
NOTICE:
It is normal to experience cosmetic
changes in the appearance of the Debris Channel
Tab during this procedure.
46 | minnkotamotors.com
button on the Indicator Panel or
button on the Remote to extend the
Down
Button
Indicator
Panel
Talon
Remote
Auto Up/
Down
Buttons
& Pairing
Button
2c
Second
Stage
First
Stage/
Spike Isolator
Spike
Retainer Pin
2d
Debris
Channel Tab
Spike Isolator
Retainer Pin
Second
Stage
Spike
First Stage/
Isolator
Spike
Third
Stage
Second
Stage
First
Stage
2c
Second
Stage
Spike
Isolator
Retainer
Pin
First
Stage/
Spike
Debris Channel Tab
2e
Second Stage
Debris Shield
Spike
Isolator
Retainer
Pin
First Stage/
Spike
©2017 Johnson Outdoors Marine Electronics, Inc.