MINN KOTA TALON Mode D'emploi page 29

Deploy the Talon from the Indicator Panel
Use the buttons on the Indicator Panel to deploy the Talon anchor.
1
a. To deploy the Talon, press the Down
the Indicator Panel.
b. While the anchor is deploying, the action can be
paused on the panel by either pressing the Down
button again, or pressing the Up
c. The paused deployment can be resumed by pressing
the Down
d. Once the deploying anchor gets to its full length of
travel or comes in contact with the bottom, it will go
through an anchoring sequence determined by the
current Mode and then stop.
NOTICE:
When two Talons are paired, to control a
Talon individually it must be deployed from its own
Indicator Panel.
NOTICE:
The Depth Indication LEDs display the depth that the anchor is deployed in 20% increments. Each Depth
Indication LED will flash while moving through it's depth percentage, and turn solid when that depth percentage is passed.
The first Depth Indication LED will flash blue as soon as the Talon is deployed. If the anchor stops for any reason while it is
in the top 20% of the deployment sequence, the top LED will stay solid. The top Depth Indication LED will always illuminate
to a solid color if the Talon is not fully retracted. The bottom Depth Indication LED will only illuminate solid when the Talon
has reached 100% deployment.
Take care that neither you nor other persons approach the Talon too closely, while operating, neither with body parts nor with
objects. The Talon is powerful and may endanger or injure you or others. While the Talon is operating, watch out for persons
swimming and for floating objects. Persons who lack the ability to run the Talon or whose reactions are impaired by alcohol, drugs,
medication, or other substances are not permitted to use this product.
The Talon is equipped with a Deployment Notification Alarm. The Alarm is needed to comply with warranty requirements and when
properly installed the alarm will only sound when the ignition key is turned on when the Talon is not fully retracted. Boat control may
be affected by a deployed Talon. Take note of the Alarm, and always watch to make sure that the Talon is fully retracted while the
boat is operating.
©2017 Johnson Outdoors Marine Electronics, Inc.
CONTROLLING THE TALON WITH THE INDICATOR PANEL
button on
button.
button again.
WARNING
Indicator Panel
Up Button
Down Button
NOTICE:
to keep the Talon deploying. The Talon will automatically
continue to deploy when the button is pressed until it has
reached its full deployment length, received input to stop
or completes anchoring.
CAUTION
You do not need to press and hold the button
minnkotamotors.com | 29