MINN KOTA TALON Mode D'emploi page 10

INSTALLING THE TALON
4. Talon to Hull Clearance - The bottom edge of the Talon should
never be less than 4" above the hull directly below the Talon to
prevent spray and drag conditions.
5. Talon to Engine Clearance - When selecting a mounting location
make sure that no interference exists between the Talon and
your engine during normal operation. Once you have selected
your mounting location, trim the engine all the way up and all the
way down, and steer the engine fully to and away from the side
selected. Ensure there is a minimum of two to three inches of
clearance from any point on the Talon.
4
Bottom Edge
of Talon
4" Minimum
Hull directly
below Talon
If these conditions are not met, please consider using a optional adapter plate. There are many adapter plates that allow for greater
adjustability of the mount and allow for greater clearances to operate the Talon. Please visit
selecting and installing an adapter plate.
Follow all instructions and heed all safety considerations. Minn Kota recommends having a second person help with installation. Not
following proper installation and rigging instructions may result in injury. Mounting the Talon too low can cause undue drag from
the Talon or Mounting Bracket when operating the boat. It is important to mount the Talon as recommended to avoid unsafe driving
conditions.
TOOLS AND RESOURCES REQUIRED
• Drill
• 5⁄16" Drill Bit
• 1⁄2" Box End or Socket Wrench
• 9⁄16" Box End or Socket Wrench
• Marine Grade Sealant
10 | minnkotamotors.com
4
Bottom Edge
of Talon
4" Minimum
Hull directly
below Talon
CAUTION
• Cable Ties
• Tape Measure
• 30ft/lb capacity Torque Wrench
• Pencil or similar marking tool
• Pliers
NOTICE:
All bass boats should mount the Talon as
flush with the bottom of the Talon mounting bracket as
possible to mitigate spray while underway.
NOTICE:
In some instances, boat manufactures have
begun to make hollow boat Transoms. We recommend
speaking to your local boat dealer or OEM Manufacturer
for mounting recommendations.
5
2"
Minimum
Outboard Motor
Range of Motion
minnkotamotors.com
• A second person to help
with installation
• Heat Shrink with Adhesive
• Wire no smaller than 12AWG
• Voltmeter
2"
Minimum
to learn more about
©2017 Johnson Outdoors Marine Electronics, Inc.