Stowing And Deploying The Motor; Push-To-Test Battery Meter - MINN KOTA Terrova Manuel Du Propriétaire

For safety reasons, disconnect the motor from the battery/batteries when the motor is not in use or while the battery/batteries are being
charged. If the motor control is left on and the propeller rotation is blocked, severe motor damage can result.
AutoPilot
The AutoPilot Indicator is located on the Indicator Panel on the Mount. It is illuminated green
illuminated when AutoPilot is not engaged.
Stow Deploy Lever
The Stow Deploy Lever is located at the top of the mount. The Stow Deploy Lever functions to unlatch the Fall Away Ramps which rotate to guide
the Lower Unit. The Stow Deploy Lever is actuated by pressing it down.

STOWING AND DEPLOYING THE MOTOR

To Deploy the Motor
Loosen the Depth Collar, then push firmly down on the Stow Deploy
Lever to release the Lift Assist Collar and slide the motor forward, out
from the Fall Away Ramp. Lower the motor to the desired depth. Make
sure it clicks into a secure, vertical position. Once at the desired depth,
slide the Depth Collar against the Lift Assist Housing and tighten.
To Stow the Motor
Loosen the Depth Collar and depress the Stow Deploy Lever. Raise the
motor by pulling up on the Shaft or Control Head. Pull the motor toward
the stern until it rests securely on the Fall Away Ramp and the Fall
Away Ramps captures the Lower Unit. Slide the Depth Collar down and
secure it against the top of the Lift Assist Housing to secure the motor
in place and prevent accidental deployment.

PUSH-TO-TEST BATTERY METER

This motor is equipped with a Push-to-Test Battery Meter.
The LED located on the Indicator Panel on the Mount of the motor.
The Battery Meter provides an accurate display of the remaining
charge in the battery. It is only accurate when the motor is off. The
meter reads as follows:
• One light indicates recharge.
• Two lights indicate low charge.
• Three lights indicate good charge.
• Four lights indicate full charge.
Moving parts can cut or crush. The Lift Assist Housing can come off of Steering Housing and create a crushing hazard. Keep fingers clear of all
moving parts.
©2022 Johnson Outdoors Marine Electronics, Inc.
STOWING AND DEPLOYING THE MOTOR
CAUTION
When stowing or deploying the motor, keep fingers clear of all hinge
and pivot points and all moving parts.
The Control Head will create a pinch point if the Depth Collar Knob
is loosened and the Control Head slides to the top of the Depth
Collar. Grasp the Shaft and prevent it from sliding all the way down
to prevent the pinch point.
Practice proper ergonomics when stowing and deploying the motor
to prevent injury.
Indicator Indicator
Panel Panel
WARNING
when AutoPilot is engaged and it is not
WARNING
WARNING
minnkotamotors.com | 29
Push-to-Test Push-to-Test
Battery Meter Battery Meter