Reset The Fuse; Replacing The Spike - MINN KOTA TALON Mode D'emploi

RESET THE FUSE

In the event that you need to reset the factory installed 30 amp Fuse, follow the instruction below. The fuse should be located no more
that 7 inches from the Positive Battery terminal on the Positive Lead (+). If an alternate Fuse is installed, please refer to directions by
your Fuse manufacturer to correctly reset it.
1
a. Remove the protective cover from the Fuse Assembly,
exposing the 30 amp Fuse.
b. Reset the Fuse by pushing the Breaker Button to
engage the Fuse.
c. Ensure that the Seal is in place, and replace the
protective housing on the Fuse Assembly. Make sure
that the Cover snaps together to provide a watertight
seal.

REPLACING THE SPIKE

The Spike for your Talon comes with a lifetime guarantee. See
the Warranty section of the manual for further details. In order to
replace the Spike, you must have enough room to extend the
entire First Stage and the beginning of the Second Stage of the
Talon. Determine if you have room to replace the Spike in the
vertical position. If there is not enough space to replace the
Spike in the vertical position, it may be required to remove the Talon from the Mounting Bracket. The Talon Tilt Bracket (1810222) is an
accessory available to make this process easier. With this accessory, you don't have to remove the Talon from the mount to replace the
Spike as it allows the Talon to be rotated into a horizontal position.
TOOLS AND RESOURCES REQUIRED
• Pin Punch 1/8"
©2017 Johnson Outdoors Marine Electronics, Inc.
1a
1c
Seal
• Hammer
Cover
Cover
NOTICE:
The Talon Tilt Bracket accessory (1810222) is
available to make this process easier. With this accessory,
you don't have to remove the Talon from the mount to
replace the Spike.
• 3/32" Allen Wrench
RESET THE FUSE
1b
Breaker
Button
Fuse
minnkotamotors.com | 45