MINN KOTA TALON Mode D'emploi page 14

INSTALLING THE TALON
7
ITEM(S) NEEDED
NOTICE:
We recommend a second person to help
with this step of the installation.
n. Next the Talon Assembly should be installed on the
Mounting Bracket. Take the Talon Assembly (Item
#B) and notice that there is an Assembly Track
located on both sides of the Talon.
o. When the Talon is properly oriented as it would
be installed, there is a single Vertical Stop Bolt
located on the Starboard side of the Talon along the
Assembly Track. The Vertical Stop Bolt is used as a
reference point or guideline to stop the Talon and
position the Mounting Straps in the Assembly Track.
Ensure that the Vertical Stop Bolt is secured in the
approximate final position.
p. Carefully lift the Talon Assembly into the Mounting
Bracket and align the Mounting Straps with the
Assembly Track. Slide the Guard Washers to the
inside wall of the Mounting Bracket, so that they sit
between it and the Talon Assembly. Slide the Talon
Assembly down the Assembly Tracks until it comes in
contact with the Vertical Stop Bolt.
14 | minnkotamotors.com
#B x 1
Talon
7n
Assembly
Assembly
Track
Assembly
Track
Mounting
Straps
7p
Talon
Assembly
Mounting
Strap
Assembly
Track
Mounting
Bracket
7o
Vertical
Stop Bolt
Talon
Assembly
Port Starboard
7p
Talon
Assembly
Vertical
Stop Bolt
Mounting
Bracket
Assembly
Track
©2017 Johnson Outdoors Marine Electronics, Inc.