Verifying Installation - MINN KOTA TALON Mode D'emploi

INSTALLING THE POWER CABLE AND DEPLOYMENT NOTIFICATION ALARM WIRE

Verifying Installation

Once installation is complete, use the following procedure to verify installation and confirm your Talon is ready to use.
1
a. For this test your Talon must be able to deploy and
make contact with the ground without hitting any
obstructions. Carefully inspect the area around the
Talon for any obstructions that may interfere with
deployment.
b. If using a battery selector, or power disconnect
switch, turn the selector switch to the "on" position.
On the Indicator Panel of the Talon are three buttons
needed for this verification, the Up
Down button and the Mode
Mode button. Confirm that the Mode Indicator
is unlit. If it is not, press the Mode button until the
Mode Indicator flashes between green and red and
then turns off.
2
c. Stand clear of the Talon and push the Down
button. The Talon spike will begin to deploy. The
Depth Indication LEDs on the Indicator Panel will
track the progress of the Talon as the Spike deploys.
d. When the Spike comes in contact with the ground,
the unit will automatically shut off. After the initial
shut off, you will hear two (2) additional deploy
cycles (or clicks), each 3-seconds apart from the
initial ground contact.
e. If the Talon functions as described above, press the
Up button. The Talon will fully retract. If the
Talon does not function as described, double check
all wiring connections and verify proper polarity to
white and black power leads and retest.
NOTICE:
To perform the same test using the
remote instead of the buttons on the Indicator
Panel, use the Anchor Mode
button, and the Down
To deploy the anchor on the remote, the Down
button must be double pressed.
20 | minnkotamotors.com
button, the
button. Press the
button, the Up
button on the remote.
Indicator Panel
Up Button
Anchor Mode
Button
Down Button
Talon
Trailered
Boat
Deployed
Spike
Ground
©2017 Johnson Outdoors Marine Electronics, Inc.
Talon
Mode LED
Remote
Anchor
Mode
Button
Auto Up/Down
Buttons
Indicator Panel
Up
Button
Anchor
Mode
Button
Down Button