MINN KOTA TALON Mode D'emploi page 32

CONTROLLING THE TALON WITH THE INDICATOR PANEL
Toggle the Work Light Color and Intensity on the Indicator Panel
The Work Light on the Talon has a high - medium - low intensity setting of white LEDs and blue LEDs. When the Work Light is turned
on, the LEDs will be either white or blue, and then an intensity setting can be selected.
1
a. When the Work Light is "off", press the Light
button once on the Indicator Panel to turn the
light "on". The light will turn on with the last light
intensity and color selection that was used.
b. If the Light
5 seconds, the lights will move to the next intensity
and/or color. Continue to press the Light
until the desired light is selected. If more than
5 seconds passes between any button press, the
current color and setting will be "saved" to memory,
and the Work Light will turn "off" instead of toggling
to the next selection.
Change the Intensity of the LEDs in the Indicator Panel
The Indicator Panel LEDs, by default, are at the brightest setting. It is possible to change the intensity of the LEDs to meet personal
preference or adjust them to fit the ambient lighting conditions. The LED's can toggle between three intensities; high, medium and low.
1
a. Press and hold the Light
b. Continuing to hold the Light
the Indicator Panel LEDs to begin toggling through
3 different intensities of high, medium, and low.
Release the Light
the desired intensity.
NOTICE:
Using the Light
Indicator Panel is the only way to change the
intensity of the LEDs in the panel. The LEDs are
programmed from the factory to be at the highest
intensity by default.
32 | minnkotamotors.com
button is pressed again in less than
button
button for 2 seconds.
button will cause
button once you have achieved
button on the
Indicator Panel
Light Button
Work Light
Indicator Panel
Light Button
©2017 Johnson Outdoors Marine Electronics, Inc.