MINN KOTA TALON Mode D'emploi page 31

Toggle the Mode from the Indicator Panel
Toggle the Mode on the Indicator Panel when the water or anchoring conditions change to fit your anchoring needs.
1
a. The Mode can be toggled from the Indicator Panel by
selecting the Mode
LED displays the Mode that the Talon is currently set
to. Press the Mode
Mode.
b. When no color is present on the LED, the Talon is in
Standard Mode. When the LED is Green, the Talon
is in Soft Bottom Mode. When the LED is Red, the
Talon is in Rough Water Mode.
NOTICE:
When the Talon is paired with a second
Talon, pressing the Mode Button on the Talon will
toggle the Mode for both Talons. Read the "Using
the Talon" section of this manual to learn more
about Modes.
Toggle the Work Light "on" and "off" with the Indicator Panel
The Work Light is an accessory light at the top of the Talon. When the Work Light is turned "on", the LEDs can be either white or blue.
1
a. To Toggle the Work Light "on", press the Light
button on the Indicator Panel. To toggle the Work
Light "off" wait 5 seconds and press the Light
button again.
NOTICE:
When the Talon is paired with a second
Talon, pressing the Light
will toggle the light for both Talons.
WARNING
The Work Light on the Talon is not intended for navigational
purposes. The Work Light does not replace or act as a
substitute for proper navigation lighting of your vessel.
Failure to properly light your boat may cause harm or serious
injury.
1
©2017 Johnson Outdoors Marine Electronics, Inc.
CONTROLLING THE TALON WITH THE INDICATOR PANEL
button. The Mode Indicator
button to toggle to the desired
button on the Talon
Indicator
Panel
Mode
Indicator
LED
Anchor Mode
Button
Soft
Bottom Mode
(green)
Standard Mode
(toggle, then unlit)
Indicator Panel
Light Button
Work Light
Rough
Water Mode
(red)
minnkotamotors.com | 31