Adding/Removing Remotes; To "Learn" Remotes; To Erase All Remotes From The Receiver - MINN KOTA COPILOT Manuel Du Propriétaire

ADDING/REMOVING REMOTES

The CoPilot remote came from the factory already "Learned" by the CoPilot receiver. Any additional remotes must be "Learned"
by the receiver. The receiver stores all "Learned" information even when the motor is disconnected from a power source.

To "Learn" Remotes

Your receiver may learn up to ten remotes. Any additional remotes can be "Learned" using the following steps. This will also work
to "Learn" any remote if all remotes are erased from the receiver.
1
a. Using a small blunt object such as a pen or
screwdriver, press and hold the Learn Button
located on the side of the receiver.
b. The receiver will emit a continuous tone.
2
c. Press any button on the remote.
d. The receiver will beep 4 times confirming that it
has "Learned" the remote successfully.
NOTE:
"Learning" the same remote will not
overwrite previously "Learned" remotes. If the
receiver has "Learned" ten remotes, "Learning"
an eleventh remote will overwrite the first
remote.

To Erase All Remotes from the Receiver

1
a. Remove power from the CoPilot receiver by
disconnecting the Power Cables, or by making
sure that the breaker, if equipped, is "off".
©2016 Johnson Outdoors Marine Electronics, Inc.
Learn Button
Right Sideplate
Power Cables
COPILOT
minnkotamotors.com | 13