Stowing And Deploying The Motor; Push-To-Test Battery Meter; Adjusting The Depth Of The Motor - MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire

Mount Ramp
The Mount Ramp functions to hold the Lower Unit in place when the motor is stowed. The Lower Unit will rest on the Mount Ramp
when stowed, helping to secure it in place.
If a propeller encounters an obstruction while running, the increased electrical current being generated by the obstruction will signal the motor to
decrease the power to the propeller to prevent damage. If the current overload is detected for more than 20 seconds, the prop will be disabled to
prevent damage to the motor. In this event, the operator can turn the prop back on after being sure that the obstruction has been cleared.

STOWING AND DEPLOYING THE MOTOR

To Deploy the Motor
Loosen the Depth Collar, then push firmly down on the
Deploy-Assist Lever to release the Latch Collar and slide the motor
forward, out from the Mount Ramp. Lower the motor to the desired
depth. Make sure it clicks into a secure, vertical position. Once
at the desired depth, slide the Depth Collar against the Steering
Housing and tighten.
To Stow the Motor
Loosen the Depth Collar and depress the Tilt Lock Lever and raise the motor by pulling up on the composite shaft or control head.Pull the
motor toward the stern until it rests securely on the Mount Ramp and the Deploy-Assist Lever captures the Latch Collar. Slide
Collar down and secure it against the top of the Steering Housing to secure the motor in place and prevent accidental deployment.

PUSH-TO-TEST BATTERY METER

This motor is equipped with a Push-to-Test Battery Meter. The LED
lights are located on the Indicator Panel on the Mount of the motor.
The Battery Meter provides an accurate display of the remaining
charge in the battery. It is only accurate when the motor is off. The
meter reads as follows:
• One light indicates recharge.
• Two lights indicate low charge.
• Three lights indicate good charge.
• Four lights indicate full charge.
MOTOR ADJUSTMENTS

Adjusting the Depth of the Motor

Once the boat is on the water, it may be necessary to adjust the Lower Unit up or down to achieve an optimum depth for motor
performance. When setting the depth of the motor, be sure the top of the motor is submerged at least 12" below the surface of the
water to avoid churning or agitation of surface water.
©2021 Johnson Outdoors Marine Electronics, Inc.
ADJUSTING THE DEPTH OF THE MOTOR
WARNING
When stowing or deploying the motor, keep fingers clear of all
hinge and pivot points and all moving parts. Practice proper
ergonomics when stowing and deploying the motor to
prevent injury.
Indicator Panel
WARNING
the Depth
Push-to-Test
Battery Meter
minnkotamotors.com | 21