MINN KOTA TALON Mode D'emploi page 34

CONTROLLING THE TALON WITH THE REMOTE
Selecting a Talon to Operate with the Remote
The Talon Selection button toggles the Talon that the remote is controlling, when 2 Talons are installed on the boat. The selection
toggles between a Talon mounted on the Port or Starboard side of the boat, or it can control both Talons at the same time. The Talon
Selection LED's are lit based on the selection made.
1
a. To toggle the Talon selected, press the Talon
Selection
Talon is selected.
b. When the button is pressed, one or both of the Talon
Selection LEDs will be lit. If the remote is oriented
so the LEDs are facing upward, the arrow on the right
will be lit when the Starboard Talon is selected. If
the arrow on the left is lit, the Port Talon is selected.
If the LED in both arrows is lit, both Talons are
selected.
NOTICE:
When two Talons are paired to the
remote, the anchors may not be in sync when
retracting and deploying.
34 | minnkotamotors.com
button, repeatedly until the desired
Port Starboard
Talon Remote
NOTICE:
The Talon Remote will always remember the
last selection made unless the remote or Talon lose power.
Talon Selection LEDs
Talon Selection
Button
Auto Up/Down
Buttons & Pairing
Button
©2017 Johnson Outdoors Marine Electronics, Inc.