MINN KOTA TALON Mode D'emploi page 47

3
f. Locate the Spike Retainer Screw and remove it using
a 3/32" Allen Wrench.
g. Once removed, the Spike should pull free from the
Second Stage along with the Spike Retainer and an
O-ring that is in place around the Spike. The Spike
Retainer is the piece that the Spike Retainer Screw
was just removed from.
h. Discard the Spike Retainer Screw, Spike, O-ring
and Spike Isolator that were just removed. Keep the
Spike Retainer for reassembly.
4
i. Take the new Spike and locate the groove along one
end. Slide the new Spike Isolator and then O-ring
onto the Spike on the end where the groove is
located. Slide them down so they are 5 to 6 inches
past the end of the Spike.
j. Locate the raised ring on the inside curve of the
Spike Retainer and align it with the groove at the end
of the Spike. Place the Spike Retainer on the Spike
so that it is keyed in place by aligning the raised ring
and groove.
5
k. Slide the assembly back into the Second Stage
and replace the Spike Retainer Screw in the Spike
Retainer using a 3/32" Allen Wrench.
l. Once the Screw is secure, close the Second Stage
Debris Shield.
m. Push the O-ring and Spike Isolator towards the
Second Stage and until they are in position against
the Spike Retainer and Second Stage Debris Shield.
©2017 Johnson Outdoors Marine Electronics, Inc.
Spike Retainer
0-ring
Raised Ring
Groove
Spike
0-ring
Spike
Isolator
5k
Spike Retainer
0-ring
Second
5l
Stage Second Stage
Debris Shield
Spike
Isolator
Retainer
Pin
First Stage/
Spike
REPLACE THE SPIKE
Second Stage
Debris Shield
Spike Retainer
Screw
First Stage/
Spike
Spike Retainer
Spike Isolator
Screw
Second Stage
Debris Shield
Second
Stage
Spike Retainer
Screw
Spike
Isolator
Spike
Second
5m
Stage
Spike
Isolator
Retainer
Pin
Spike
Isolator
First
Stage/
Spike
minnkotamotors.com | 47