Using And Adjusting The Motor; Adjusting The Depth Of The Motor; Adjusting The Steering; Controlling Speed & Direction - MINN KOTA ENDURA MAX Mode D'emploi

USING & ADJUSTING THE MOTOR

ADJUSTING THE DEPTH OF THE MOTOR

When setting the depth be sure the top of the motor is submerged at least
12" to avoid churning or agitation of surface water. The propeller must be
completely submerged.
1. Firmly grasp the composite shaft and hold it steady.
2. Loosen the steering tension knob and adjustable depth collar knob until
the shaft slides freely.
3. Raise or lower the motor to the desired depth.
4. Tighten adjustable depth collar knob to secure the motor in place.
CAUTION:
• Never operate your motor when it is out of the water.
• Over-tightening the clamp screws can damage the bracket.
• Never loosen the steering tension knob without securely
holding the shaft of the motor. Failing to do so will cause the
motor to rapidly fall against the bracket.

ADJUSTING THE STEERING

• Adjust the steering tension knob to provide enough tension to allow the
motor to turn freely, yet remain in any position without being held
• Tighten the knob to place the motor in a preset position to leave your
hands free for fi shing.
CONTROLLING SPEED AND DIRECTION WITH THE TILLER:
These motors are equipped with an extension twist tiller with a telescoping handle, which off ers variable forward and reverse
speeds. The speed control may be operated in either direction, forward or reverse. Turn the tiller handle counterclockwise from
(OFF) to increase reverse speed and clockwise from (OFF) to increase forward speed. Thrust decreases as you approach (OFF)
from either direction.
10 | minnkotamotors.com
OR
REVERSE
Adjustable Depth Collar Knob
Steering Tension Knob
12" Minimum
Depth
FORWARD
©2014 Johnson Outdoors Marine Electronics, Inc.