Mount Installation - MINN KOTA RIPTIDE SE Manuel De L'utilisateur

TOOLS AND RESOURCES REQUIRED:
• Phillips Screw Driver
• Drill
• 9/32" Drill Bit
• 7/16" Box End Wrench
• A second person to help with the installation
1. Before you proceed, determine the desired mounting location for the motor. It is recommended that the motor be mounted as
close to the center line of the boat as possible as seen below.
CAUTION: Make sure the motor is mounted on a level surface and is not connected to a power source.
2. Verify the area under the chosen mounting location is clear and safe to drill through.
3. Place the motor on top of the desired mounting location while it is in the stowed position (for stow and deploy instructions,
see "Stowing and Deploying the Motor" on p. 11).
4. Verify the motor rest is positioned far enough beyond the edge of the boat so that the motor clears all obstructions while
deploying and stowing the motor.
6 | minnkotamotors.com

MOUNT INSTALLATION

©2014 Johnson Outdoors Marine Electronics, Inc.