Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE COPILOT
Your new CoPilot accessory comes with everything you'll need to directly install it on your trolling motor. These instructions are
intended to show how to install your CoPilot into the PowerDrive. Please review the parts list, mounting considerations and tools
needed for installation prior to getting started. For additional product support, please visit minnkotamotors.com.
INSTALLATION PARTS LIST
Item /
Part #
Description
Assembly
CTRL BOARD V2 COPILOT RECEIVER
A
2994112
TRANSMTR, ASY, PD/AP COPLT (SUB)
B
2994020
SCREW-#8 X 5/8 PPHSMS S/S
1
2373418
CTRL BOARD V2 COPILOT RECEIVER
2
2374092
p
MANUAL - CO-PILOT POWERDRIVE
2377166
MOUNTING CONSIDERATIONS
We recommend installing your CoPilot while the boat is on your trailer in a stable position. The motor should be secured and
disconnected from a power source before beginning installation.
TOOLS AND RESOURCES REQUIRED
•
#2 Phillips Screw Driver
•
#3 Phillips Screw Driver
✖ This part is included in an assembly and cannot be ordered individually.
p Not shown on Parts Diagram.
6 | minnkotamotors.com
INSTALLATION
Qty.
1
1
2
1
1
WARNING
1
A
2
B
©2016 Johnson Outdoors Marine Electronics, Inc.
Publicité
Chapitres
Table des Matières
Dépannage
