Mount Installation - MINN KOTA RIPTIDE Mode D'emploi

TOOLS AND RESOURCES REQUIRED:
• (2) 1/2" Wrenches
• Standard or Needle Nose Pliers
• A second person to help with the installation
INSTALLATION OF MOTOR TO MOUNT
1. With mount closed as shown below, use two 1/2" wrenches to remove one of the two nylock nuts and washers from the
upper pin and remove pin from mount.
NOTE: The two bushings in the upper arm may come out. If so, keep them for re-assembly.
2. Using a pair of pliers, remove the spring clip on freshwater models (or the E-clip on saltwater models) from the lower pin and
remove lower pin from mount.
6 | minnkotamotors.com

MOUNT INSTALLATION

Upper Arm
Lower Aluminum Bracket/Arm
Lower Aluminum Bracket/Arm
Bushing
Upper Pin with
Nut and Washer
Lower Pin
Upper Arm
Upper Pin with
Nut and Washer
Upper Pin with
Nut and Washer
Bow Guard
Lower Pin
Bow Guard
Lower Pin
Spring Clip
©2015 Johnson Outdoors Marine Electronics, Inc.