Declaration Of Conformity - Control Techniques Commander SE Guide D'utilisation

Control Techniques, The Gro, Newtown, Powys, UK, SY16 3BE
SE11200025 SE11200037
SE2D200075 SE2D200110
SE23400075 SE23400110
SE33200550 SE33400550
SE43401850 SE53402200
The AC variable speed drive products listed above, have been designed and manufactured in
accordance with the following European harmonised, national and international standards:
EN60249 Base materials for printed circuits
IEC60326-1 Printed boards: general information for the specification writer
Printed boards: specification for single- and double-sided printed boards with plated-
IEC60326-5
through holes
IEC60326-6 Printed boards: specification for multilayer printed boards
Insulation co-ordination for equipment within low-voltage systems: principles, requirements
IEC60664-1
and tests
EN60529 Degrees of protection provided by enclosures (IP code)
UL94 Flammability rating of plastic materials
UL508C Standard for power conversion equipment
*EN50081-1 Generic emission standard for the residential, commercial and light industrial environment
EN50081-2 Generic emission standard for the industrial environment
EN50082-2 Generic immunity standard for the industrial environment
Adjustable speed electrical power drive systems - Part 3: EMC product standard including
EN61800-3
specific test methods
Electromagnetic compatibility (EMC), Limits, Limits for harmonic current emissions
**EN61000-3-2
(equipment input current <16A per phase)
Electromagnetic compatibility (EMC), Limits, Limitation of voltage fluctuations and flicker in
***EN61000-3-3
low-voltage supply systems for equipment with rated current < 16A
*Applies to Size 1 units only.
**SE11200025, SE11200037, SE11200055: input choke required. All other units where input
current <16A: for professional use only.
***Applies to the following models: SE11200025 - SE11200075, SE2D200075, SE2D200110,
SE23400075 - SE23400220, SE23400300, SE23400400, SE33400550, SE33400750.
These products comply with the Low Voltage Directive 73/23/EEC, the Electromagnetic
Compatibility (EMC) Directive 89/336/EEC and the CE Marking Directive 93/68/EEC.
These electronic Drive products are intended to be used with appropriate motors,
controllers, electrical protection components and other equipment to form complete end
products or systems. Compliance with safety and EMC regulations depends upon installing
and configuring Drives correctly, including using the specified input filters. The Drives
must be installed only by professional assemblers who are familiar with requirements for
safety and EMC. The assembler is responsible for ensuring that the end product or system
complies with all the relevant laws in the country where it is to be used. Refer to this User
Guide. A Commander SE EMC Data Sheet is also available giving detailed EMC information.
Commander SE User Guide
Issue Number 9

Declaration of Conformity

SE11200055
SE2D200150
SE23400150
SE33200750
SE53403000
SE11200075
SE2D200220
SE23400220 SE23400300
SE33400750 SE43401100
SE53403700
W, Drury
Executive VP Technology
Date: 1 November 2001
SE23200400
SE23400400
SE43401500