Mechanical Installation - Control Techniques Commander SE Guide D'utilisation

equipment.
If it is necessary to meet strict emission limits, or if it is known that electromagnetically
sensitive equipment is located nearby, then full precautions must be observed. These
will include the use of RFI filters at the drive inputs, which must be located very close to
the drives. Space must be made available for the filters and allowance made for
carefully segregated wiring. Both levels of precautions are given further on in this
chapter.
Hazardous areas
The drive must not be located in a classified hazardous areas unless it is installed in an
approved enclosure and the installation is certified.
4.3

Mechanical installation

4.3.1 Drive and Mounting Dimensions
Drive A
Size mm in mm
1 191 7.520 175
2 280 11.024 259
3 336 13.228 315
4 412 16.220 389
22
F
C
D
Figure 4.1 Size 1 to 4 Drive and mounting dimensions
B C
in mm in mm
6.890 102 4.016 130 5.118 181.5 7.146
10.197 147 5.787 130 5.118
12.402 190 7.480 155 6.102
15.315 250 9.843 185 7.283
www.controltechniques.com
G
B A E
F
Commander SE Size 1 & 2
4 x M4 holes in heatsink
Commander SE Size 3 & 4
4 x M5 holes in heatsink
D E
in mm in mm
265 10.433 121.5 4.783 121.5 4.783
320 12.598 172
397 15.630 228
Commander SE User Guide
F G
in mm in
84 3.307 84 3.307
6.772 164 6.457
8.976 217 8.543
Issue Number 9