Display Messages; Status Mode; Selecting And Changing Parameters - Control Techniques Commander SE Guide D'utilisation

Masquer les pouces Voir aussi pour Commander SE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.2

Display Messages

6.2.1

Status mode

In status mode, left hand display indicates a two letter mnemonic indicating the status of
the drive:
Display
rd
ih
tr
dC
Load indications - see parameter 22
Display mnemonic
Speed indications - see parameter 23
Display mnemonic
The frequency or speed on the display is the post ramp reference. It does not
NOTE
include slip compensation, if applied.
6.2.2
Parameter View Mode
In parameter view mode, the left hand display flashes a parameter number. The right
hand display shows the value of that parameter.
6.2.3
Parameter Edit Mode
In parameter edit mode, the right hand display flashes the value of the parameter
number which is being shown in the left hand display.
The following diagram and procedure shows how to select and then edit parameters:
6.3

Selecting and changing parameters

This procedure is written from the first power up of the drive and assumes no
NOTE
terminals have been connected, no parameters have been changed and no
security has been set.
Commander SE User Guide
Issue Number 9
Status
The drive is enabled and ready for a start command.
Drive ready
The output bridge is inactive.
The output bridge is inactive for a period of 2
seconds because the drive is disabled, or a coast to
Drive inhibited
stop is in progress, or the drive is inhibited during a
trip reset. The inhibit time of 2 seconds cannot be
changed.
The drive has received a trip signal. (The trip code
Drive has tripped
will be displayed in the right hand display).
DC injection braking current is being applied to the
DC injection braking
motor.
Ld
Active current as a % of motor rated active current
A
Fr
SP
Cd
www.controltechniques.com
Explanation
Explanation
Drive output current per phase in A
Explanation
Drive output frequency in Hz
Motor speed in rpm
Machine speed in Customer defined units
47

Publicité

Table des Matières
loading

Table des Matières