Handling And Programming; Display And Keypad; Programming Keys; Control Keys - Control Techniques Commander SE Guide D'utilisation

6

Handling and Programming

6.1

Display and keypad

The display and keypad are used for the following:
• Displaying the operating status of the drive
• Displaying fault or trip codes
• Reading and changing parameter values
• Stopping, starting and resetting the drive
Figure 6.1 Display and Keypad (as seen when the AC supply is connected to the
6.1.1

Programming keys

The MODE key is used to change the mode of operation of the display.
If the MODE key is pressed and then released within 2 seconds, the display will change
from Status Mode to Parameter View Mode.
If the MODE key is pressed and held down for 2 seconds then the Status Mode will
change from speed indication to load indication and vice versa. See Parameters 22 and
23.
The drive will remember the displayed units on power down (speed or load) such that the
same units are presented on the next power up.
The INCREASE &
their values. Also, in keypad mode, they are used to increase and decrease the speed of
the motor.
6.1.2

Control keys

The RUN key is used in keypad mode, to START the drive.
The STOP/RESET key is used in keypad mode, to STOP and RESET the drive. It
can also reset the drive in terminal control.
The FORWARD/REVERSE key is used in keypad mode to change direction of
rotation of the motor (when parameter 26=On).
46
Sign LED
drive)
DECREASE keys are used to select parameters and edit
www.controltechniques.com
Display
Control Keys
Programming
keys
Commander SE User Guide
Issue Number 9