Saving Parameters; Security Codes; Setting A Security Code - Control Techniques Commander SE Guide D'utilisation

6.4

Saving parameters

Parameters are automatically saved when the mode button is pressed when going from
parameter edit mode to parameter view mode.
6.5

Security codes

A security code is locked into the drive when parameter 25 is set to any value other than
0 and then Loc is selected in parameter 10 and the STOP/RESET key pressed.
Once a security code has been locked, parameter 10 will automatically reset to L1. Now
view only access to parameters 1 to 9 is available.
Parameter 10 may be changed by the user to L2 to allow view only access to all the
parameters (1 to 54). In this case, parameter 25 will indicate a value of 0 so as not to
reveal the programmed security code.
6.6

Setting a security code

1. Set parameter 10 to L2 to allow access to parameter 25.
10
2. Set parameter 25 to a security code e.g. 5.
25
pressed. The display should show:
3. Set parameter 10 to Loc and then press the STOP/RESET key to initiate the
security code
10
4. Parameter 10 will automatically reset to L1
10
5. Security will also be set if the drive is powered down after a code has been set into
parameter 25.
48
Press
Hold
2 secs PARAMETER VIEW MODE
Select parameter to change
Press
Parameter number flashing
PARAMETER EDIT MODE
Change parameter value
Press
Parameter value flashing
Figure 6.2 Selecting and changing parameters
L2
5
This code changes to 0 once the MODE key is
Loc
L1
www.controltechniques.com
STATUS MODE
Press
or
or
25 0
Commander SE User Guide
4 mins
timeout
Issue Number 9