Publicité
TROUBLESHOOTING
Incorrect operations are often for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical
appliances being used. If the trouble cannot be rectified even after execising the checks listed below, ask your nearest
PIONEER authorized service center or your dealer to carry out repair work.
1. Disc table is not ejected when
Power cord is not properly plugged into AC wall | e
Plug in power cord.
4 is pressed.
socket.
—
e
Power switch is not turned on.
e Turn on power switch.
Clean disc.
e
Setthe disc properly.
e
Remove disc and let player stand for 1 to
2 hours until it is dry.
e Try to alleviate the warp.
(Refer to
Symptom 7, remedy column.)
Disc is dirty.
e
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
2. Disc table comes out.
Disc is warped.
Aim the remote
control
unit at the
projection monitor or AV amplifier.
e
The CONTROL
IN terminal on the rear panel is
connected to pioneer projection monitor or AV
amplifier.
e
Batteries are weak.
e
There is an obstacle between the player and the
remote control unit.
e
Remote control unit is not in a good location for
transmission.
3. Remote control does not work.
e
Replace batteries.
e
Remove the obstacle or shift the remote
control position.
e
Operate the remote control unit in front
of the player.
Some TV sets have remote control functions that
operate improperly in response to the remote control
unit of the player.
e
Movethe TV andthe player further apart,
or cover the remote sensor of the TV
during disc playback.
4. Operation of the remote control
unit causes the TV to operate
improperly.
WHEN A LASERVISION DISC IS BEING PLAYED
5. Disc is rotating but there is no | e The TV set is not turned on.
e Turnon TV.
picture.
e
Wrong connections from player to TV.
e
Make correct connections.
6. Picture
continuously
moves
le TheTVverticalholdcontrolis notadjusted properly. | e
Adjust vertical-hold control on TV.
vertically.
7. Particular disc does not playback | e The playing surface of the disc is dirty.
e
Usea
soft cloth and lightly wipe off the
properly. The playback stops in
dirt from the surface of the disc. If
the middle of the disc program.
necessary, moisten a cloth with diluted
neutral detergent to remove heavy dirt or
fingerprints.
e The disc is warped.
LD discs only
Put the disc into the protective envelope,
then
place
it on
a flat desk
top.
Subsequently, place a flat board on the
disc, and load it with about 4 ~ 5 kgs. If it
isleftin this state for one day, sometimes
the warp will be alleviated.
Heavy books
Flat board
Protective
Flat board
envelope
80
<VRE1021>
En
Publicité
