Search Loops For Offset Drive Home - Viking MI 422 Manuel D'utilisation

The docking station (1) is installed in
mowing area A. Mowing area B is linked
to mowing area A by means of a
corridor (2). The perimeter wire (3) can be
continuously followed by the robotic
mower. In order to mow mowing area B,
starting points (4) must be defined.
( 10.15)
Individual mowing operations can then be
started at the starting points, depending on
the setting (starting frequency).
122
Installing the start and end of the
corridor:
The perimeter wire (1) must be routed in a
funnel shape as shown at the start and end
of the corridor (clearances A and B).
This prevents the robotic mower from
accidentally driving into the corridor during
mowing.
A = 22 cm
B = 6 cm
Installing corridor:
Wire clearance in corridors: 22 cm
This results in the following space
requirements:
– between high obstacles (over 2 cm in
height – e.g. walls):
88 cm,
– between paths / obstacles that can be
travelled on (lower than 2 cm in height –
e.g. paths):
22 cm.
In corridors, the perimeter wire (1) must be
routed parallel and attached to the ground
with a sufficient number of fixing pins (2).
At the start and end of the corridor, funnel-
shaped entrance and exit areas must be
installed.
11.11 Search loops for offset drive
home
If offset drive home is activated, search
loops must be provided
0478 131 9934 A - EN