Installing Linking Sections; Guide Loops For Offset Drive Home - Viking MI 632 M Manuel D'utilisation

In corridors, the perimeter wire (1) must be
routed parallel and attached to the ground
with a sufficient number of fixing pins (2).
At the start and end of the corridor, funnel-
shaped entrance and exit areas must be
installed.

12.9 Installing linking sections

The robotic mower ignores the perimeter
wire signal if the wires are routed parallel
and close together. Linking sections must
be installed:
– where secondary areas are to be
installed. ( 12.7)
– where no-go areas are necessary.
( 12.6)
0478 131 9937 B - EN
VIKING recommends laying linking
sections together with the relevant
no-go areas or secondary areas
during wire routing.
In the case of retrospective
installation, the wire loop must be
cut and linking sections must then
be integrated using the wire
connectors supplied. (
In linking sections, the perimeter wire (1)
must be routed parallel, the wires must not
cross and must be close to one another.
Attach the linking section to the ground
with a sufficient number of fixing pins (2).

12.10 Guide loops for offset drive home

If staggered drive home is activated, guide
loops must be provided.
Function:
When the robotic mower follows the
perimeter wire offset at a distance, it
crosses one of these guide loops during
the drive home. It then travels to the
perimeter wire and on to the docking
station.
Guide loops with an internal docking
zone:
12.14)
To the right and left next to the two
outermost docking stations, two guide
loops (1) have to be installed at an angle of
90° to the perimeter wire.
Minimum distance to the docking stations:
2 m
141