Docking Station; Led On The Docking Station - Viking MI 422 Manuel D'utilisation

Insert loose, unstripped wire ends (1) to
the stop in the wire connector (2). Press
the wire connector together using suitable
pliers – ensure correct engagement.
Attach the perimeter wire strain relief to the
ground with two fixing pins as shown.
0478 131 9934 A - EN

12. Docking station

12.1 LED on the docking station

A red LED (1) provides information on the
status of the docking station and the wire
signal.
Red LED illuminates continuously
Red LED flashes slowly
Red LED flashes rapidly
Red LED flashes at intervals
LED does not illuminate
Red LED illuminates continuously:
The docking station is switched on and the
robotic mower is not docked.
Red LED flashes slowly:
The docking station is switched on, the
robotic mower has docked successfully or
is being charged.
Red LED flashes rapidly (approx. 2x per
second):
The perimeter wire is not correctly
connected to the docking station or the
wire signal is no longer present owing to a
defective perimeter wire (wire break).
Red LED flashes rapidly at intervals:
The LED flashes alternately 3 times at a 1-
second interval, 3 times at a 2-second
interval, 3 times at a 1-second interval, 5
second pause. After the pause, the signal
is repeated.
This flashing sequence indicates a fault in
the docking station. ( 24.)
Red LED does not illuminate:
The docking station is switched off, the
wire signal is not being transmitted.
Switching on the docking station
– During automatic operation, the
docking station is switched on and off
automatically.
– Switching on manually:
Open the flap of the docked robotic
mower and press the OK or the Back
button. The robotic mower and the
docking station are switched on.
The docking station is switched on
exclusively via the docked robotic
mower.
In order to activate the docking
station, first place the robotic
mower in the docking station and
switch it on by pressing the button.
125