Viking MI 422 Manuel D'utilisation page 143

Masquer les pouces Voir aussi pour MI 422:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
Message:
1010 – iMow raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by the
hood
Remedy:
– Check movement of the hood and
confirm the message with OK
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
Message:
1105 – Flap open
Operation aborted
Possible cause:
– Flap open during automatic operation
0478 131 9934 A - EN
– Flap open during automatic edge
following
Remedy:
– Close the flap (
14.2)
Message:
1120 – Hood blocked
Check hood
Then press OK
Possible cause:
– Permanent collision detected
Remedy:
– Free the robotic mower, remove the
obstacle or change routing of perimeter
wire if necessary – then confirm the
message with OK
– Check movement of the hood and
confirm the message with OK
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check the routing of the perimeter wire;
check the clearances with the iRuler
(
11.5)
Message:
1130 – Stuck
Free iMow
Then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free the robotic mower, level out the
mowing area or change routing of
perimeter wire if necessary – then
confirm the message with OK
– Clean the drive wheels, if necessary
prevent operation during rain – then
confirm the message with OK (
Message:
1131 – Stuck
see message 1130
Message:
1135 – Outside
Place iMow in mowing area
Possible cause:
– The robotic mower is located outside
the mowing area
Remedy:
– Return the robotic mower to the mowing
area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– MI 422:
Tilt sensor has detected a slope
inclination exceeding 35%
– MI 422 P:
Tilt sensor has detected a slope
inclination exceeding 40%
Remedy:
– MI 422:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 35%
10.12)
141

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mi 422 p

Table des Matières