Viking MI 422 Manuel D'utilisation page 144

– MI 422 P:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 40%
Message:
1170 – No signal
Check wire signal
Possible cause:
– No reception of wire signal during
operation
– The robotic mower is located outside
the mowing area
– Docking station or electronic
components were replaced
Remedy:
– Check the power supply to the docking
station
– Check the LED on the docking station –
the red LED must be permanently
illuminated during operation (
– Return the robotic mower to the mowing
area
– Link the robotic mower and docking
station ( 9.8)
Message:
1180 – Dock iMow
Automatic docking
not possible
Possible cause:
– The docking station was not found
Remedy:
– Check the LED on the docking station,
switch on the docking station if
necessary ( 12.1)
– Check docking ( 14.6)
142
Message:
1190 – Docking error
Docking station occupied
Possible cause:
– Docking station occupied by a second
robotic mower
Remedy:
– Dock the robotic mower once the
docking station is unoccupied again
Message:
1200 – Mowing motor fault
see message 0505
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
12.1)
– Overload at a drive wheel
Remedy:
– Clean the robotic mower (
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
– Mowing operation has been interrupted
or not started due to rain
Remedy:
– No action necessary; adjust rain sensor
if required (
15.2)
10.12)
Message:
1230 – Docking error
Dock iMow
Possible cause:
– Docking station has been located,
automatic docking not possible
Remedy:
– Check docking, if necessary manually
dock robotic mower (
– Check perimeter wire – ensure correct
routing in the area of the docking station
( 9.6)
Message:
2000 – Signal problem
Dock iMow
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place the robotic mower in the docking
station – then press OK
Message:
2010 – Replace mowing blade
Allowed operating time reached
Possible cause:
– Mowing blade has been in use for more
than 200 hours, replacement is
necessary
Remedy:
– Replace the mowing blade, then
confirm the blade replacement in the
"Service" menu ( 15.4)
0478 131 9934 A - EN
14.6)