Setting The Rain Sensor; Setting The Status Screen - Viking MI 422 Manuel D'utilisation

9. Language:
Set the required display language.
The language selected during initial
installation is set as the default.
10. Contrast:
The display contrast can be
adjusted as required.

10.12 Setting the rain sensor

In order to set the 5-stage
sensor, press the control pad to
the left or right. The current
value is displayed in the "Settings" menu
by means of a line diagram.
The sensitivity of the rain sensor can be
adapted to the local conditions and
requirements. In particular, it is possible to
adjust how long the robotic mower waits
for the mowing area to dry following rain.
In the case of medium
sensitivity, the robotic
mower is ready for operation
under normal ambient
conditions.
Move the bar further to the
left for mowing at a higher
humidity. If the bar is moved
all the way to the left, the
robotic mower will mow even
in wet external conditions and will not
interrupt the mowing operation if rain drops
land on the sensor.
Move the bar further to the
right for mowing at a lower
humidity. If the bar is moved
all the way to the right, the
robotic mower will only mow if
the rain sensor is completely dry.
0478 131 9934 A - EN

10.13 Setting the status screen

In order to configure the status screen,
select the left or right screen with the
control pad and confirm with OK.
Charge state:
Shows the battery symbol with the
charge state in percent
Rem. time:
The remaining mowing duration
during the current week in hours and
minutes
Time and date:
Current date and current time
Start time:
Start of the next planned mowing
operation. During a running active
time, the text "active" is displayed.
Mowing ops:
Total number of mowing operations
performed
Mowing hours:
Total duration of all mowing
operations performed
Distance:
Total distance covered
10.14 Installation
1. Passage:
Switch offset drive home on and off.
When the passage is activated, the robotic
mower travels back home to the docking
station, offset at a distance, along the
perimeter wire.
Three variants can be selected:
Off – default setting.
The robotic mower travels along the
perimeter wire.
Narrow – 40 cm
The robotic mower alternatively travels
along the perimeter wire or offset by
40 cm.
Wide – 40 - 80 cm
The distance to the perimeter wire is
selected randomly within this passage
during each drive home.
In conjunction with an external
docking station, search loops must
be installed for offset drive home.
( 11.11)
Offset drive home can only be
activated when the perimeter wire
has been routed with a clearance of
at least 2 m at the narrowest
sections.
2. ASM (anti-stuck manoeuvre):
The robotic mower starts an evasive
routine if it becomes stuck when ASM is
switched on.
On – default setting.
Off – ASM should be switched off if there
are large, flat expanses in the mowing
area (e.g. asphalt driveways) or if the
robotic mower often unexpectedly turns a
90° corner during operation.
3. New installation:
The installation assistant is started
again, the existing mowing plan is
deleted. ( 9.4)
4. Starting points:
The robotic mower either starts the
mowing operation at the docking
station (default setting) or at a starting
point.
Starting points are to be defined
– if partial areas are to be travelled to in a
targeted manner because they are
insufficiently mowed,
113