Flap; Adapting The Programming - Viking MI 422 Manuel D'utilisation

Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g following a lengthy break).

14.2 Flap

The robotic mower is equipped with a flap
which protects the display from the
weather and from inadvertent operation. If
the flap is opened during use of the robotic
mower, operation is stopped and the
mowing blade and robotic mower come to
a standstill.
Opening the flap:
For safety reasons, the Stop button
must be pressed before opening
the flap during operation of the
robotic mower.
Grasp the flap (1) at the lifting point (A)
and release upwards by pulling lightly.
Open the flap as far as the stop.
0478 131 9934 A - EN
The opened flap can be removed
upwards from the machine. This
design is implemented for safety
reasons: This ensures that the
machine cannot be lifted and
carried by the flap.
Closing the flap:
Carefully fold the flap downwards and
allow to engage.
The robotic mower can only be
operated when the flap is fully
engaged.

14.3 Adapting the programming

The current programming can be seen in
the Mowing plan. ( 10.6)
The mowing plan is calculated based on
the size of the mowing area during
installation or during the creation of a new
mowing plan.
The active times and the mowing
duration can be changed individually, the
required mowing operations themselves
are automatically distributed over the
possible active times. If required, several
mowing or charging operations can run
during an active time. If required, the edge
of the mowing area can be cut
automatically at regular intervals.
( 10.14)
Up to three different active times per day
are possible. ( 10.6)
If the robotic mower has to travel to
specific areas of the mowing area, starting
points must be defined. ( 10.15)
Under certain circumstances (e.g.
warm weather or generous time
window), not all the active times
may be necessary for optimal lawn
care.
Changing the active times: (
– Additional active times for further
mowing operations.
– Adapting the time window in order, for
example, to prevent mowing during the
morning or night.
– Omitting individual active times
because the mowing area is e.g. being
used for a party.
Extending the mowing duration: (
– There are areas which are not mown
sufficiently, e.g because the mowing
area has lots of corners.
– Intensive grass growth during the
growing period.
– Particularly dense lawn.
Reduction of the mowing duration:
( 10.8)
– Reduced grass growth due to heat, cold
or dryness.
Creation of a new mowing plan: (
– The size of the mowing area has been
changed.
New installation: ( 10.14)
– New location of the docking station.
– Initial operation on a new mowing area.
10.7)
10.8)
10.6)
127