Roger Technology EDGE1 Instructions Et Consignes Pour L'installateur page 85

•
gate leaves must not move.
•
•
of the position recovery phase when opening and when closing.
• For SMARTY Series automation systems with absolute encoder installed, disconnect and reconnect power. Perform
manoeuvre is not performed.
• If
21
Maintenance
Perform scheduled maintenance every 6 months.
If the unit contains dirt, moisture, insects or other foreign matter, disconnect from mains power and clean the board
and the housing.
Repeat the initial installation test procedure after cleaning.
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
SMARTY 5R5 and 7R
22
Disposal
The
removing the product correctly and safely. This product consists of numerous different materials. Some of
management facilities indicated by local legislation applicable for this category of product.
Do not dispose of this product as domestic refuse. Observe local legislation for differentiated refuse collection, or hand
the product over to the vendor when purchasing an equivalent new product.
Warning! Some parts of this product may contain substances that are harmful to the environment or dangerous and
23
Additional information and contact details
ROGER TECHNOLOGY is the exclusive proprietor holder of all rights regarding this publication.
or any alterations to this document are prohibited without express prior authorised from by ROGER TECHNOLOGY.
ROGER TECHNOLOGY reserves the right to modifying or perfecting the product, which will not imply a FW version change.
In the absence of an instruction manual revision, it is understood that these instructions hold good for this and for
subsequent FW versions of the control unit.
This instruction manual and the warnings for the installer are given in printed form and are included in the box
containing the product.
The digital version of this documentation (PDF) and any future updates are available from the reserved area of our
website www.rogertechnology.com/B2B, in the Self Service section.
ROGER TECHNOLOGY CUSTOMER SERVICE:
business hours: Monday to Friday
Telephone no: +39 041 5937023
To request support for any problems or for any other queries regarding the automation system, please compile the
online form "REPAIRS" in the 'Self Service' area of our website www.rogertechnology.com/B2B.
85