Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
The gate does not
open or close.
Acquisition proce-
dure does not com-
plete correctly.
Remote
control
has limited range
and does not work
while
automated
gate is moving.
is not working.
With gate stops,
(ASSt)
-
gular duty cycle (1
s on / 4 s off).
Message
to-
gether with audible
(POS1)
warning signal.
(with
SMARTY/
EMA only)
(POS2)
Gate open indica-
tor lamp does not
work.
Gate does not per-
form desired ma-
noeuvre.
N.B.: Press the TEST button to temporarily cancel the alarm.
The next time a command is received, the alarm reappears on the display if the problem has not been resolved.
ALARM
POSSIBLE CAUSE
Incorrect installation of the motors
Position detected of MOTOR 2 incon
gruent with travel length.
Incorrect installation of the motors
Flat batteries.
(btLO)
The motor supply voltage is dropping,
the control unit is assessing whether
low battery voltage.
.
TEST button pressed accidentally.
Safety devices in alarm state.
Excessive voltage drop.
Travel length error.
The radio transmission is impeded by
metal structures and reinforced con
crete walls.
Flat batteries.
wires disconnected.
Maintenance alarm.
reading is in progress.
reading is in progress.
Bulb blown or wires disconnected.
Motor leads crossed.
Incorrect selection of the battery type. Change the value of the parameter
ACTION
SMARTY motors with SMARTY/EMA installed
must not be installed to open the door towards
the learning procedure.
Replacing the encoder is recommended if the
problem persists.
SMARTY motors with SMARTY/EMA installed
must not be installed to open the door towards
Wait for mains power to be restored.
No intervention, it is a waiting phase to give a
Repeat acquisition procedure.
device/s in alarm state and the connections of
the safety devices.
Repeat acquisition procedure.
Move gate into completely closed position and
repeat the procedure.
Install the antenna.
Replace the transmitter batteries.
Perform a maintenance programm.
To reset the alarm, release the protection by
inputting the password (
TEST for 5 s. The message
followed by the messages
4 seconds: to reset the alarm, hold down the
is displayed.
the display and the alarm is not reset.
The manoeuvre counter resets.
The number of hours
control unit, and the count is reset.
N.B.: when 8000 hours of manoeuvres are
exceeded, the maintenance alarm is disabled
entirely.
At start of each manoeuvre, the control unit
acquires the position of MOTOR 1.
If the position is not read successfully, the
message
is shown on the display.
At start of each manoeuvre, the control unit
acquires the position of MOTOR 2.
If the position is not read successfully, the
message
is shown on the display.
and repeat
) and press
is displayed,
appears on
is stored by the
.
81
Publicité
