Roger Technology EDGE1 Instructions Et Consignes Pour L'installateur page 64

11.2
Acquisition procedure
PROG
AP P-
x4 s 1 click
x2 s
AU AU to to AU to
• Press and hold PROG for 4 seconds.
• Press PROG again.
• MOTOR 1 starts opening at low speed.
• After the delay time set with parameter
•
for 2 s.
• When the message
delay set with parameter
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
• : acquisition error
• :
launching a new acquisition procedure.
For more information, see chapter 15 "Alarms and faults".
64
PROG
AU to
2
PARAM. 26
MOTOR 2 DELAY
CLOSING TIME
is shown on the display.
is shown on the display.
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
(default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop is reached.
1
PARAM. 25
MOTOR 1 DELAY
OPENING TIME
2
1
MOTOR 1 CLOSED
CLOSING
2
1
MOTOR 2
OPEN
OPENING
Sì