Publicité
Les langues disponibles
Les langues disponibles
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
When the manoeuvre hour limit (set by
1500 manoeuvre hours).
IMPORTANT: "manoeuvre" means every motor opening activation.
The message
s on / 4 s off) until system maintenance is performed and the alarm is reset.
To reset the alarm, release the protection by inputting the password (
is displayed, followed by the messages
until
is displayed.
The number of hours
If the value
=
Manoeuvre hours.
Example:
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example:
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
• Press and hold the
•
•
Temporary unlock procedure:
• Enter the password.
•
Password cancellation procedure:
• Enter the password (
• Save the values
• Use the UP
• Press and hold the + and - buttons for 4 seconds.
•
indicate that no password is set).
• Switch the control unit off and on again (
Changing password
Protection deactivated.
Protection activated.
78
and
appears on the display and the alarm is not reset.
is stored by the control unit, and the count is reset.
=
is exceeded (8000 hours of operation) the maintenance alarm is no longer managed.
= 123 hours.
= 123 days.
=
,
buttons to view the parameter
and/or DOWN
=
.
=
).
,
,
,
=
buttons to view the parameter
and/or DOWN
to
.
) is exceeded, the visual maintenance signal is activated (e.g. every
to
.
,
and
.
.
.
=
).
) and press TEST for 5 s. The message
=
).
,
,
and
Publicité
