Publicité
Les langues disponibles
Les langues disponibles
CONTACT
29 (ANT)
30
32(ORO)
31(COM)
33(AP)
37(COM) Open control signal input (N.O.).
34(CH)
37(COM) Close command input (N.O.).
35(PP)
37(COM) Step by step mode command input (N.O.).
36(PED)
37(COM) Partial open control signal input (N.O.).
ABSOLUTE ENCODER
(SMARTY EMA)
RECEIVER CARD
BATTERY CHARGER
B71/BCHP
BATTERY KIT
2x12
4,5 Ah
(B71/BCHP/EXT)
Only AGM type
EXP
DESCRIPTION
Use RG58 if an external antenna is used; maximum recommended length: 10 m.
N.B.
IMPORTANT: persistent activation of the opening command prevents automatic reclosure; the auto
matic reclosure time count is resumed when the opening command is released.
The function of the control is determined by parameter
On double leaf gate automation systems, by default, the partial opening command opens LEAF 1
completely.
Absolute encoder installed on SMARTY Series motors. Its installation (which is a factory standard for
During travel acquisition, the encoder reading is acquired in the completely open and completely
closed positions. During normal operation, the encoder reading is acquired at each motor start, except
in the case of direction inversion due to activation of the sensing edge, the obstacle detection system
or the photocells, or requested by the user with a command.
N.B.: The absolute encoder is connected in parallel with the motor phases. Normally, the encoder will
emit a short audible signal (whistle). If no audible signal is heard, the encoder may be disconnected,
absent or damaged.
For SMARTY REVERSIBLE: the encoder is already assembled and installed in the factory by ROGER
TECHNOLOGY. The reading of the position by absolute encoder, only when the door is completely
closed or open, is preceded by a slow rotation of the motor (duration 1 second) which discharges the
mechanical voltage from the reduction before starting the manoeuvre. This ensures a softer start and
eliminates any noise.
For SMARTY IRREVERSIBLE: product code SMARTY/EMA is available for installing the encoder on
the motor.
Enable the encoder with the parameter
IMPORTANT
parameter
If parameter
The control unit has two radio remote control functions by default:
– PR1
– PR2
shows
red or until the battery voltage drops below the minimum permissible limit. In this case,
Low) is shown on the display and the control unit accepts no commands.
If mains power is lost while the gate is moving, the gate stops and then automatically resumes the
interrupted manoeuvre after 2 seconds.
parameters
and
.
To reduce battery consumption, the positive power feed wire of the photocell transmitters and receiver
may be connected to terminal SC
unit disconnects power from the accessory devices when the gate is completely open or completely
closed.
WARNING! the batteries must always be connected to the electronic control unit in order to charge.
For more information, refer to the installation manual for the B71/BCHP battery charger.
Connector for B74/BCONNECT WiFi IP device.
This IP device allows, using any internet browser, the complete management of the control panel
.
and perform the travel acquisition procedure.
SMARTY/EMA installed, repeat the travel acquisition procedure
).
or
).
(Battery
59
Publicité
