Publicité
Les langues disponibles
Les langues disponibles
16
TEST
x5 s
INFO mode may be used to view certain parameters measured by the EDGE1 controller.
stationary. The control unit displays the following parameters and the corresponding measured values in sequence:
Parameter
Function
.
Displays the position of MOTOR 1 / MOTOR 2, expressed in revolutions and relative to total length, at the time
of the test.
If the MOTOR 1 / MOTOR 2 is stationary, the current absorption value is 0. Activate a command function to test
current absorption.
voltage is too low, compare the parameters read with values indicated as follows with the motor stationary:
Display current, expressed in Amperes, used to compensate for strain detected by MOTOR 1 / MOTOR 2 due,
for example, to low external temperatures (e.g.: 0 = 0 A ... 4 = +3 A). At the beginning of a manoeuvre from the
completely open or completely closed position, if the control unit detects a strain higher than the value stored
in its memory during the travel acquisition cycle, the controller automatically increases the current delivered to
MOTOR 1 / MOTOR 2.
Display current threshold, expressed in Amperes, at which the obstacle detection function (crush prevention)
of MOTOR 1 / MOTOR 2 is triggered. This value is calculated automatically by the controller in relation to the
settings of parameters
For the motor to function correctly,
E.g. 1.000 = 1 s / 0.120 = 0.12 s (120 ms). Ensure that the manoeuvre time is more than 0.3 s.
2000, the controller disables the motor. A value exceeding 500 indicates that the characteristics of the connec
tion cable are inadequate for the installation or that the connection cable is too long or of inadequate cross
section, or may indicate an electrical fault of the brushless motor.
If the control unit is capable of identifying the position of the gate leaf when the test is conducted, the following
is shown on the display:
Indicates the state of the automation system (open/closed).
Displays the number of hours remaining before the maintenance alarm is activated. The number is preceded by
• Pressing
as 0.0.0.0. .
• Pressing
on both motors;
• If only one motor is connected to the control unit, the parameters relative to "MOTOR 1" only are displayed.
• Use the + / - buttons to scroll through the parameters. When the last parameter in the sequence is reached, press
the - button to return through the previous parameters.
• In INFO mode, the automation system may be activated to test operation in real time.
• The two motors may be controlled independently in OPERATOR PRESENT mode, ignoring the position data request
82
,
and
automation system opening (motor active).
automation system closing (motor active).
automation system completely open (motor not actives).
automation system completely closed (motor not actives).
mains voltage too low or overload.
motors overcurrent.
(DOWN arrow): view number of hours of last maintenance service. The first service is indicated
(UP arrow): return to remaining hours display.
.
.
.
.
must always be lower than the value
TEST
TO QUIT
...
THE INFO MODE
.
/
, in seconds.
1 click
Publicité
