NC contact (normally closed). The gate always reverses.
opening.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
opening.
STEP MODE.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote control
is active. The parameter
The remote control turns the courtesy light on and off. The parameter
(1)
mand. Example: parameters
•
seconds by pressing CHB on the remote control. Press CHB to activate partial opening.
Selecting courtesy light mode
NOTE: the parameter is not visible if par.
Disabled.
From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
COS2
is ignored.
(1)
(1)
(1)
(1)
and
set:
other than
(ORO)
is ignored.
75