Roger Technology EDGE1 Instructions Et Consignes Pour L'installateur page 80

15
Alarms and faults
PROBLEM
POWER LED off
POWER LED off
The gate does not
open or close.
Example:
80
ALARM POSSIBLE CAUSE
No power.
Fuses blown.
Input mains power voltage fault.
Control initialisation failed.
Overcurrent detected in inverter.
Incorrect connection between SEC1
and SEC2 of the transformer.
Incorrect travel length values.
Parameter
Motor 1 not connected.
Motor 2 not connected.
Fuse F1 blown or damaged.
This message is not visible if control
ler is in battery power mode.
MOTOR 1 encoder not responding,
absent or faulty.
MOTOR 2 encoder not responding,
absent or faulty.
Communication error between con
troller and MOTOR 1 encoder.
Communication error between con
troller and MOTOR 2 encoder.
Minor malfunction of MOTOR 1 en
coder.
Minor malfunction of MOTOR 2 en
coder.
Encoder MOTOR 1 encoder magnet
malfunction. Severe encoder error.
Encoder MOTOR 2 encoder magnet
malfunction. Severe encoder error.
Position detected of MOTOR 1 incon
gruent with travel length.
ACTION
Replace fuse. Always disconnect from mains
power before removing fuses.
Disconnect from mains
10 seconds then reconnect to the mains and
switch on. If the problem persists, contact
and possible assistance.
Pressing the TEST button it is possible to hide
the alarm temporarily and consult the control
unit's parameters.
Press the TEST button twice or perform 3
command requests in succession.
Swap the connection between SEC1 and SEC2.
device/s in alarm state and the connections
of the safety devices.
cal stops of MOTOR 1 and MOTOR 2 are posi
tioned correctly.
Repeat acquisition procedure.
The position data request message
pears on the display whenever this parameter
appears on the display, then repeat the acqui
sition procedure (see chapter 11.2).
Replace fuse.
Always disconnect from mains power before
Replacing the encoder is recommended if the
problem persists.
Replacing the encoder is recommended if the
problem persists.
Replacing the encoder is recommended if the
problem persists.
Replacing the encoder is recommended if the
problem persists.
the learning procedure.
Replacing the encoder is recommended if the
problem persists.
power, wait
ap
and repeat