Roger Technology EDGE1 Instructions Et Consignes Pour L'installateur page 60

8
Function buttons and display
UP
DOWN
PROG
• Press the UP and/or DOWN
•
• Press and hold the + or -
• To save the new value, wait a few seconds or move onto another parameter with the UP
•
9
Switching on or commissioning
Power the control unit.
P4.30.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 7.
10
Display function modes
10.1
Parameter display mode
PARAMETER
PARAMETER
See chapter 11 for detailed descriptions of the parameters.
60
BUTTON
DOWN
TEST
buttons to view the parameter you intend to modify.
4
30
DESCRIPTION
UP Next parameter
Previous parameter
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Programme travel
TEST Activate TEST mode
or DOWN button. The