Publicité
Les langues disponibles
Les langues disponibles
Enable safeguarded gate closure/opening
Enabling this parameter ensures that the gate is not left open due to an incorrect and/or accidental command.
This function is NOT enabled if:
•
the gate receives a STOP command;
•
the sensitive edge intervenes, detecting an obstacle in the same direction in which the function is enabled. If instead
the sensitive edge detects an obstacle during the movement opposite to the one guaranteed, the function remains
active.
•
the number of closure attempts set by parameter
•
Disabled. The parameter
Safeguarded closure enabled.
After a period of time set with parameter
less of the parameter
Safeguarded closure / opening enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Selecting limitations in battery operation
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An error alert may
be activated via the COR output (if parameters
When the battery voltage drops under the threshold selected with par.
commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command.
Battery type selection and consumption reduction
NOTE:
shows the message
Battery 24
Battery 24
Battery 36
battery life.
Battery 36
Selection of the battery operation management
Setting a value different than
via parameter
The control unit always accepts commands until the battery is completely exhausted.
The command becomes active when the battery voltage drops to the minimum threshold (22
The command becomes active when the battery voltage drops to the medium threshold (23
The command becomes active when the battery voltage drops to the maximum threshold (24
76
is not displayed.
, and then closes the gate.
.
.
is different than
(if set to
or
(2x12
) with B71/BCHP. Acceleration/deceleration/speed reduction enabled, to increase the battery life.
(2x12
) with B71/BCHP. No performance reduction, maximum battery consumption.
(3x12
) with external charger. Acceleration/deceleration/speed reduction enabled, to increase the
(3x12
) with external charger. No performance reduction, maximum battery consumption.
and an error alert can be activated through the COR output via parameter
has been reached;
=
.
and
are adequately set).
and the battery is 2x12
) or an error alert
, the control unit
), and then the gate closes.
, the control unit accepts only opening
.
the control unit, after a prelamping of 5s,
.
.
for battery 2x12
for battery 2x12
for battery 2x12
)
)
)
Publicité
