Roger Technology EDGE1 Instructions Et Consignes Pour L'installateur page 74

Selecting the type of photocell test on input FT1
This parameter is visible if
The test lasts max. 3 s OFF / 3 s ON.
Selecting the type of photocell test on input FT2
This parameter is visible if
The test lasts max. 3 s OFF / 3 s ON.
Photocell test disabled.
Photocell test enabled on opening ONLY.
Photocell test enabled on closure ONLY.
Photocell test enabled on both opening and closure.
Method and management of SMARTY 5R5- SMARTY 7R automation reversibility
This parameter is visible ONLY if
NOTE:
The SMARTY 5R5/7R motor is always REVERSIBLE.
mains power, when the motor is not running.
WARNING:
The SMARTY 5R5/7R motor is REVERSIBLE ONLY when the controller is NOT powered.
force of the motor is counteracted
If the unit is not powered, the gate leaf can be moved manually without releasing the motor (in both opening and
closure).
WARNING
IMPORTANT! Always disconnect from mains power and (if applicable) battery power before disconnecting the terminal
board of the motor from the controller or disconnecting any of the motor wires.
Setting motor stop distance
01= faster deceleration/shorter stop distance ... 05= slower deceleration/longer stop distance.
Select number of motors installed
N.B.:
(see chapter 11).
1 motor.
2 motors. IMPORTANT: Use the same type of motor for both gate leaves.
Enabling absolute encoder (SMARTY Series automation systems only)
Attention: the parameter
REVERSIBLE motor.
NB: the position data request message
Attention: SMARTY motors with SMARTY/EMA installed must not be installed to open the door towards the outside
Disabled.
Enabled. Perform or repeat the acquisition procedure to acquire the parameters relative to the installation. N.B: see
chapter 12 for more information on the absolute encoder.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
74
N.C.
N.C.
N.C.
or is set.
or is set.
or
must be set and SMARTY/EMA installed for all applications with the SMARTY
appears on the display, then repeat the acquisition procedure (see chapter 11.2).
COS1
N.C.
N.C.
N.C.
.
N.C.
N.C.
N.C.